3
KT-315 Compliance Specifications
FCC & IC Compliance
This device complies with Part 15 Class B of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received including interference that may
cause undesired operation. This class B digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations.
CE Compliance Notice
This product is in conformity with EMC Directive 2004/108/EC based on results using harmonized standards in accordance with
article 10(5) and LVD Directive 2006/95/EC based on results using harmonized standards. This product is labeled with CE mark
as proof of compliance with the above mentioned European Directives.
CE & RCM Compliance
• EN50133-1: Alarm systems - Access control systems for use in security applications: system requirements.
• EN55022:2006 Class B Digital Emissions.
UL Compliance Notice
To comply with UL listings, the following requirements must be met:
• Use of a UL listed computer.
• Use of UL listed readers (Wiegand 26 and 34 bits, mag stripe 26 and 34 bits, have been tested and found to comply).
• Use of a UL recognized tamper switch on every housing cabinet for the KT-315.
• Do not use the SmartLink option.
• Use the Kantech IP Link Enhanced Ethernet Device.
• Use the KT3-LCD module on each KT-315 controller (should be installed near the controller).
• Do not use a 220 V transformer (not UL listed).
• Europe version not evaluated by Underwriters Laboratories.
• Use only UL listed cables.
• Use only UL listed adaptors.
• Use only a UL listed transformer such as Kantech TR1640P/UL or DSC PTD1640.
• Use Kantech BD7-12 battery.
• The KT-CAB3000LDR and KT-CAB4000LDR have been evaluated by UL as alternate enclosures.
• KT-PC4108A/KT-PC4216 modules mounted in the KT-4051CAB not evaluated by Underwriters Laboratories.
• This product complies with the following UL 294 performance levels:
• Line Security: I
• Destructive Attack: I
• Endurance: IV
• Standby Power: IV
NOTE: Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 of UL294, fifth
edition.
NOTE: All circuits are power limited with the exception of the battery leads.
The following Kantech readers are UL1076 listed and can be used with the Kantech Model KT315 in a UL294 compliant
installation: P225W26, P225KPW26, P225KPXSF, P225XSF, P325W26, P325KPW26, P325XSF, P325KPXSF, and P600.
Overview
The KT-315 operates with the EntraPass software.
Innovative and Powerful
The Kantech KT-315 Door Controller is designed to meet the highest standards of access control and point monitoring
applications.
To Next Page
Loading...
