Quick Reference Guide
..- .. -.-.-.-.-.-.....
(For a complete description of these commands and their format, see the Reference Manual.)
The 30 commands available as shipped from the factory, and their use, are:
ASCn Places the RAM Plus in ASCII mode.
AMTOR Places the RAM Plus in AMTOR STANDBY mode. If a SELCAL is specified, start
a link with the specified station.
BKONDEL When ON echoes a backspace-space-backspace sequence to the screen each time
you press the backspace key to erase errors from your screen. When OFF, echoes a \ for each
press of the backspace key.
CONNECT Used to establish a packet connection with another station on the current port
(HF or VHF) and stream.
CONYERS Places the RAM Plus in Convers mode.
CW Places the RAM Plus in CW mode.
DISCONNE Used to disconnect from a packet station you have been talking to.
DAYTIME Used to set the clock in the RAM Plus.
DELETE Determines the character received from the computer which will cause the previous
character to be removed from the transmit buffer.
DISPLAY Causes a screen display of all RAM Plus parameters.
DWAIT Time delay imposed to insure that packet digipeaters have priority access to the radio
frequency.
ECHO When ON characters you type on the keyboard are echoed back to your terminal. When
OFF characters you type are not be echoed.
FEC Places the RAM Plus in AMTOR FEC mode.
HELP Displays a complete list of all available commands on your screen.
INTFACE Selects the abbreviated (30) command set or the complete (over 200) command set.
Also used to place the RAM Plus in HOST, BBS, or KISS mode.
K Places the RAM Plus in Convers mode (same as CONVERS).
LAMTOR Places the RAM Plus in the Listen AMTOR mode.
MONITOR When ON allows the RAM Plus to display monitored packets on the screen. When
OFF, no packets will be displayed unless someone actually connects to you. To monitor Pactor
stations in the PACTOR STANDBY mode, this command must be ON. Other non-packet modes
are not affected by this command.
MHEARD Displays a short list of packet stations that have recently been heard by your RAM
Plus.
MYCALL Used to set the call sign of your RAM Plus. This is transmitted with every packet. It
is also used as the Pactor call sign of your station by default.
MYPBBS Sets the call sign used for your personal mailbox in the RAM Plus.
PACTOR Places the RAM Plus in PACTOR STANDBY mode. If a callsign is specified, starts
a link with the specified station. You may monitor other Pactor stations in this mode if
MONITOR is ON.
PBBS Used to set the size (Kbytes) ofthe Personal BBS in your RAM Plus.
GETTING STARTED
G16
April 15, 1993 KAM Plus
© Copyright 1993, Kantronics Co., Inc. All Rights Reserved.
Duplication of this manual or the firmware without permission of Kantronics Co .• Inc. is prohibited.
To Next Page
Loading...
