Kantronics KPC-4 - Page 12

MAXUSERS.
This
command
causes
the
TNC
to
allocate
the
memory
required
for
the
maximum
number
of
simultaneous
connections
you
wish
to allow.
The
KAM and
KPC-4
will
allow
a
setting
of
0.
If
MAXUSERS
is
set
to
0/0,
these
TNCs
will
accept
only
one
connect
at
a
time
from
either port of
the
TNC.
This
special
condition
will
be
highlighted
by
being
displayed
simply
as
MAXUSERS
0.
This
makes it
feasible
to
use
the
KAM/KPC-4
with
MBL
or
RLI
BBS
programs
on two
frequencies.
Setting
MAXUSERS
to
0/n
or
n/0
will
disable
the
port
designated
for
0.
PMODE (KAM only). When set to NONE as defaulted, the KAM will be in the Packet
Mode. This command allows you to have your KAM come on in the mode you select.
Optional parameters are: ASCII, AMTOR, CW, FEC, RTTY, NAVTEX and NONE
(packet). Starting the KAM in the Kiss or Host Mode is accomplished with the
INTFACE command (INTFACE will override PMODE). As with all commands this
must be PERMed for the KAM to remember it after being turned off (if not using the
Battery Backup or SmartWatch).
6 INTRO
. O Copyright 1989, 1990, Kantronics, Inc. All Rights Reserved.
Version 3.0 Aug. 13, 1990 Duplication of this manual or the firmware without
Operations Manual permission of Kantronics, Inc. is prohibited.