Kantronics KPC-4 - Page 36

The
long
(JHEARD
L)
version
of
this
command
will
also
show
the
destination
field
and
the
digipeaters
used.
This
list
would
look
like:
(KAM)
LAWKAN/H* >WYXI
VIA KSKU, TOP*, KSKU
N66046/V > BEACON
WK5M-3/H* >WDYEMR
VIA WOXI, TOP*
WD@EMR/V >KC
VIA KSTOP, KCMO
(KPC-4)
LAWKAN/1* > WØXI
VIA KSKU, TOP*, KSKU
N66046/2 > BEACON
WK5M-3/1* > WDGEMR
VIA WØXI, TOP*
WDYEMR/2 >KC
VIA KSTOP, KCMO
(KPC-1,2 or 2400)
LAWKAN* > WOXI
VIA KSKU, TOP*, KSKU
N66046 > BEACON
WK5M-3* > WDYEMR
VIA WØXI, TOP*
WDYEMR >KC
VIA KSTOP, KCMO
Nodes [Short!lLong]
01/09/88 08:25:15
01/10/88 00:03:10
01/10/88 00:03:19
01/10/88 00:04:15
01/09/88 08:25:15
01/10/88 00:03:10
01/10/88 00:03:19
01/10/88 00:04:15
01/09/88 08:25:15
01/10/88 00:03:10
01/10/88 00:03:19
01/10/88 00:04:15
This command will cause the node to return a list of KA-NODES it has heard, as well
as NET/ROM or TheNet nodes. The format of the list is similar to that of the JHEARD
list above.
XConnect callsign (KAM and KPC-4 only)
This command will cause the node to issue a connect request to "callsign" in the usual
AX.25 format from the node but uses the other port of the KA-NODE. Cross-connecting
enables you to gain access via the node to another frequency.
30 KA-NODE
Version 2.85
Operations Manual
O Copyright 1989, Kantronics, Inc. All Rights Reserved.
Duplication of this manual or the firmware without
permission of Kantronics, Inc. is prohibited.