9
4. OPERATING YOUR PRESSURE WASHER
If you have followed all the instructions so far, you are
now ready to have fun cleaning the KARCHER way!!!
• Turn on the supply water and press the Spray Gun lever (No.12) until
the water flows freely and removes all air locks from the hoses.
• You may now attach the bayonet fit Spray Lance (No.14) or required
accessory to the Spray Gun.
All accessories are bayonet fit, simply push in and twist
until they click into position !
• Once water is flowing through the machine, you may now switch
on your Karcher Pressure Washer using the Power Switch (No.4)
• You can choose between four modes of operation on the Spray
Lance (No.14) by rotating the nozzle end until the symbol is aligned
with the marking on the spray lance (The marking on the spray lance
must be up during operation).
Low-pressure jet........................... for operating with detergent or for
cleaning with low pressure
High-pressure pencil jet .............. for especially stubborn spot soiling
High-pressure fan jet ................... for large area soiling
High-pressure rotating pencil jet .. for stubborn large area soiling
ONLY ROTATE THE FOUR-WAY NOZZLE
WHEN THE TRIGGER GUN IS CLOSED
WHEN USING YOUR KARCHER PRESSURE WASHER ON THE
HIGH PRESSURE SETTING, THE RECOMMENDED WORKING
DISTANCE BETWEEN THE NOZZLE AND THE OBJECT OR
SURFACE TO BE CLEANED IS 30 CM. IT CAN BE CLOSER IF
REQUIRED FOR PATIOS OR MASONERY.
When cleaning painted surfaces, ensure that the paint is sound and
there are no signs or rusting or blistering.
It is your responsibility to check the suitability of the surface to be cleaned.
Karcher (UK) Ltd. cannot be held responsible for any damaged caused.
To Next Page
Loading...
