11
English Vacuum polisher
Changing the brushes and felt discs
Always pull out the mains plug before changing the brushes or felt
discs.
Turn the unit over and simply pull off the discs. Insert the brushes or felt
discs of your choice. Ensure that the catches on the discs are locked
securely to the holding fixture.
Operating and application instructions
Before inserting the mains plug ensure that the handle is in the vertical
position. In this position the unit is switched off.
To start the unit press the handle down until loose and then pull it
towards yourself.
In order to stop the unit return the handle to the vertical position.
Cleaning and polishing the floor
Applying floor polish
Check the floor before applying the floor polish. Any grease marks
should be removed beforehand using a damp cloth. Apply a high quality
wax uniformly (follow the manufacturer’s application instructions) and
distribute over the floor using the
hard brushes. You can use a mop to
distribute liquid wax over the floor.
Polishing the floor to a normal shine
Allow the applied floor polish to dry and polish the floor to a normal
shine using the
soft brushes.
Polishing to a mirror finish
If you want to give the floor surface a really gleaming finish, after the
whole floor has been cleaned with the brushes you can polish it with
the felt discs.
The best results are achieved by pushing the polisher in a straight line.
Do not push the appliance in circles.
Storage
On completion of work you should remove the brushes or felt discs in
order to avoid damaging the bristles.
Please ensure that you move the unit on its rear wheels if you wish to
convey it to a storage location or another room; tilt the handle
backwards but do not use force.
The mains connection cable may be wrapped around the hook which is
attached to the handle.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
