Kärcher G 2000 QT User Manual

6
OPERATING INSTRUCTIONS
Step 1
Check oil level. Oil level should always be
between the FULL and ADD marks on
the dipstick. Be sure the machine is level
when checking the oil level. (Refer to the
engines operating manual for seasonal
grades.).
Step 2
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Step 3
Connect the high pressure hose to the units
high pressure outlet.
Step 4
Connect garden hose to units water inlet.
Step 5
Connect garden hose to the cold water
source and turn water on completely.
Do not use hot water.
Step 6
Unlock the lock of the trigger gun.
Trigger the gun to eliminate trapped air, wait
for a steady flow of water to emerge from
the spray nozzle.
Step 7
Slide the throttle control to the RUN position.
Step 8
Push the primer ball three times.
Wait 3 seconds between each push.
Note: in cold weather push 5 times.
Step 9
Pull the starter handle. If the engine fails to
start after 3 pulls squeeze the trigger gun
to release pressure, and repeat step 9.
Important!
Do not run the engine with a high or low
oil level as this can cause engine damage.
If you have further questions regarding the
engine, please refer to the engines
operating manual included with the unit.

Kärcher G 2000 QT Specifications

General

Brand	Kärcher
Model	G 2000 QT
Category	Pressure Washer
Language	English