Need help?Do you have a question about the Kärcher HDS 1295 S Eco and is the answer not in the manual?
General| Category | Floor Machine |
|---|---|
| Model | HDS 1295 S Eco |
| Manufacturer | Kärcher |
| Dimensions (L x W x H) | 1330 x 750 x 1060 mm |
| Voltage | 400 V |
| Frequency | 50 Hz |
| Hose Length | 10 m |
| Flow rate | 600 - 1300 l/h |
| Operating pressure | 30 - 180 bar |
| Power rating | 2800 W |
| Working Pressure | 30 - 180 bar |
| Water Flow Rate | 600 - 1300 l/h |
| Power Consumption | 2800 W |
| Lance Length | 0.5 m |
Fill the unit with diesel fuel or light fuel oil only. Never operate with an empty tank.
Set unit switch to "I". Ensure ready for working indicator lamp is lit.
Adjust the temperature regulator to the required temperature for hot water or steam cleaning.
Adjust pressure and flow using the control spindle and pressure/flow control.
Spray angle is crucial for efficiency. Use 25° fan jet nozzle normally.
Set pressure, temperature, and detergent concentration. Start from a distance.
Spray cleaning agent, let it react, then spray off loosened dirt.
Use appropriate temperatures for different cleaning tasks. Beware of scalding.
Replace nozzle, set pressure to minimum, and temperature to min. 100°C. Beware of steam.
Turn off unit, shut off water, remove plug, depressurize, and secure handgun.
Warning lamp indicates necessary maintenance work based on operating hours.
Provide container, unscrew plug, drain oil, retighten, and top up slowly.
Address motor overload or no mains voltage issues.
Check for no mains voltage or issues with the electric mains/power cord.
Check for air in the system and bleed the pump.
Check fuel tank, water supply, and fuel filter. Check rotation direction.
To Next Page