– 4
Note: The EASY!Lock system joins com-
ponents with a quick-fasten thread solidly
and securely with just one turn.
Join the spray lance with the trigger gun
and tighten until hand-tight
(EASY!Lock).
Mount the nozzle on the spray lance
(marking on the adjustment ring at the
top) and hand-tighten it (EASY!Lock).
Appliance without hose drum:
Join the high-pressure hose with trigger
gun and high-pressure connection of
the appliance and tighten until hand-
tight (EASY!Lock).
Device with hose drum:
Join the high pressure hose with trigger
gun and tighten until hand-tight
(EASY!Lock).
DANGER
Danger of explosion! Only refill diesel oil or
light fuel oil. The operation with bio diesel
as per EN 14214 (starting at an outside
temperature of 6 °C) is possible. Inappro-
priate fuels, e.g. petrol, must not be used.
ATTENTION
Risk of damage! Never operate device with
an empty fuel tank. The fuel pump will oth-
erwise be destroyed. This also applies to
cold water operation.
Open fuel filler cap.
Refill fuel.
Close tank lock.
Wipe off spilled fuel.
DANGER
Risk of injury!
– Use Kärcher products only.
– Under no circumstances vacuum sol-
vents (petrol, aceton, diluting agent etc.).
– Avoid eye and skin contact.
– Observe safety and handling instruc-
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
Fill/replace external detergent container.
몇 WARNING
Observe regulations of water supplier.
According to applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. En-
sure that the connection of your building
water installation on which the high-pres-
sure cleaner is operated is equipped with a
system separator pursuant to EN 12729
Type BA.
Water that was flowing through a system
separator is considered non-drinkable.
몇 CAUTION
Always connect the system separator to
the water supply, never directly to the appli-
ance!
For connection values refer to technical
specifications.
Attach supply hose (minimum length
7.5 m, minimum diameter 1/2“) to the
water supply set by means of a hose
clamp.
Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note: The supply hose and the hose clamp
are not included in the scope of delivery.
Connect suction hose (minimum diame-
ter 1/2“) with filter (accessory) to the
water connection point.
– Max. suck height: 0.5 m
DANGER
Risk of personal injury or damage! Never
suck in water from a drinking water contain-
er. Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.
Install the hand-spray gun, the jet
pipe, the nozzle and the high
pressure hose
Refill fuel
Fill/replace detergent container
Water connection
Suck in water from vessel
7EN
To Next Page
Loading...
