Kärcher K 2 Plus - Taking a Break; Shutting Down & Clean-Up

English 9

STEP 2:
Fill a container with Kärcher deter-
gent. Place the filter end of detergent
siphon tube into the container.
 STEP 3:
Turn on the pressure washer (I). Pull
trigger to operate unit. Liquid deter-
gent is drawn into the unit and mixed
with water. Apply detergent to work
area. Do not allow detergent to dry
on surface.
 STEP 4:
To rinse, insert the spray wand and
pull trigger to operate unit.
 STEP 5:
Cleaning up: Always draw fresh wa-
ter through the detergent tank or si-
phon tube when done to flush any
remaining detergents from the injec-
tion system.
 STEP 1:
Release trigger and engage gun
safety lock.
 STEP 2:
Turn pressure washer to OFF (0) po-
sition.
 STEP 1:
Turn the switch to OFF (0) position
and unplug cord from outlet.
 STEP 2:
Turn off the water source.
 STEP 3:
Press trigger to release water pres-
sure.
 STEP 4:
Release trigger and engage gun
safety lock.
 STEP 5:
Disconnect the garden hose from the
water inlet on the unit.
TAKING A BREAK ... five
minutes or more
SHUTTING DOWN &
CLEAN-UP