Kärcher K 5.68 M Operator's Manual

Kärcher K 5.68 M

52 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

English 2

Français 18

Español 35

59635950 02/10

K 5.68 M

HIGH PRESSURE WASHER - OPERATOR MANUAL

NETTOYEUR HAUTE PRESSION - MANUEL D'UTILISATION

MANUAL DE USUARIO DEL LIMPIADOR DE ALTA PRESIÓN

Table of Contents

Other manuals for Kärcher K 5.68 M

Questions and Answers:

V
velasquezstevenSep 5, 2025
Why is my Kärcher K 5.68 M not reaching high pressure?
- K
  kaylawilliamsSep 5, 2025
  If your Kärcher Pressure Washer isn't reaching high pressure, start by replacing the garden hose with a 5/8 inch or larger one. Then, check the garden hose for any kinks, leaks, or blockages that may be restricting the water supply. Ensure the water source is fully open to provide enough inlet water. Clean the water inlet filter by removing it and rinsing it in warm water. Finally, make sure the spray wand is set to the high-pressure position.
M
matthew11Sep 6, 2025
What to do if the Kärcher K 5.68 M output pressure varies?
- S
  Stephanie MossSep 6, 2025
  If the output pressure of your Kärcher Pressure Washer varies, ensure the water is turned on full force and inspect the garden hose for kinks, leaks, or blockages. Check that all hoses and fittings are airtight to prevent the pump from sucking air; if it is, turn off the machine and purge the pump by squeezing the trigger gun until a steady water flow emerges. Also, clean the water inlet filter by removing and rinsing it in warm water. Clear any obstructions from the discharge nozzle using a fine needle, and run distilled vinegar through the detergent suction tube to address any calcification in the gun, hose, or spray wand.
J
Jessica BradleySep 8, 2025
Why is my Kärcher K 5.68 M Pressure Washer not dispensing detergent?
- S
  Scott HerreraSep 8, 2025
  If there is no detergent coming out of your Kärcher Pressure Washer, first check that the detergent suction tube is properly connected to the machine. If the detergent is too thick, dilute it, or use Kärcher® detergent for best results. Ensure the filter on the detergent suction tube is clear by running warm water through it. If the detergent suction tube is damaged or clogged, remove any obstructions or replace the tube. Also, make sure the spray wand is in the low-pressure position and clear any blockages from the discharge nozzle using a fine needle.
O
Olivia AlexanderSep 9, 2025
How to fix a noisy pump on a Kärcher K 5.68 M Pressure Washer?
- H
  Hannah FoxSep 9, 2025
  If your Kärcher Pressure Washer pump is noisy, it might be sucking air. Ensure that all hoses and fittings are airtight. Turn off the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges through the nozzle.

Kärcher K 5.68 M Specifications

General

Flow Rate	460 l/h
Hose Length	9 m
Cable Length	5 m
Max. Inlet Temperature	40 °C
Dimensions (L × W × H)	349 x 426 x 878 mm
Voltage	230 V
Frequency	50 Hz
Power	2.1 kW
Pressure	20-140 bar / 2-14 MPa

Related product manuals

Preview: Kärcher K 5.68

Kärcher K 5.68

Preview: Kärcher K 5.50 M

Kärcher K 5.50 M

Preview: Kärcher K 5.85 M

Kärcher K 5.85 M

Preview: Kärcher K 5.20 M

Kärcher K 5.20 M

Kärcher K 5.55 M

Preview: Kärcher K 5.80 M

Kärcher K 5.80 M

Preview: Kärcher K 520 M

Kärcher K 520 M

Preview: Kärcher K 2.54 M

Kärcher K 2.54 M

Kärcher K 6.55 M

Kärcher K 270 M

Preview: Kärcher K 620 M

Kärcher K 620 M

Preview: Kärcher K 3.97 M

Kärcher K 3.97 M