English 7
Î STEP 1:
Unwind the high pressure hose
completely from the hose reel.
Î STEP 2:
Insert the spray wand of your choice
into the trigger gun. Press in against
the spring tension and twist into
locked position.
Î STEP 3:
Connect garden hose to unit’s water
inlet.
Î STEP 4:
Connect garden hose to the cold
water source and turn water on
completely.
Î STEP 5:
Plug the Ground Fault Circuit Inter-
rupter (GFCI) into a working outlet.
– Press “RESET” button.
– Press “TEST” button.
Red indicator on “RESET” button
should appear.
– Press “RESET” button again for use.
WARNING
Do not use if above test fails.
Note: The actual appearance of the GFCI
may be different from this illustration.
Î STEP 6:
Unlock the trigger gun safety lock.
Trigger the gun to eliminate trapped
air, wait for a steady flow of water to
emerge from the spray nozzle.
Î STEP 7:
Turn on the high pressure washer (I).
The motor starts only if the trig-
ger of the gun is pulled and shuts
off when the trigger is released.
OPERATING INSTRUCTIONS
To Next Page
Loading...
