Kärcher NT 27/1 Service Manual

English 5.906-472.0 Rev. 00 (08/08) 11
If the abrasive coals on the suction turbine (M1) are worn, they can
be replaced as follows.
Î Press the locking noses (2) on both sides of the cover (1) slight-
ly toward the outside and remove the cover (1) toward the top.
Î Pull off the connector plug (6).
Î Press the safety flag (4) down and pull the abrasive coal (3) out
of the abrasive coal chute (5).
Î Install the new abrasive coal in reverse order.
Note
After inserting the new abrasive coal into the abrasive coal chute,
the safety flag must be bent slightly toward the top. This secures
the abrasive coal from inadvertently slipping out of the abrasive
coal chute.
1Cover
2 Locking noses (4x)
3 Abrasive coal (2x)
4 Safety flag
5 Abrasive coal chute
6 Connection plug
5.7 Replacing the abrasive coals of the suction turbine

Kärcher NT 27/1 Specifications

General

AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Maximum input power	1380 W
Annual energy consumption	- kWh
Type	Drum vacuum
Hose length	2.5 m
Cleaning type	Dry&wet
Dust capacity	27 L
Flexible hose	Yes
Product color	Black, Grey, Yellow
Tube material	Metal
Container material	Plastic
Dust container type	Bagless
Airflow	67 l/s
Proper use	Professional
Noise level	72 dB
Cable length	7.5 m
Vacuum air filtering	-
Handles quantity	1
Standard nominal width	35 mm

Weight and Dimensions

Width	420 mm
Height	525 mm
Weight	7500 g