Kärcher SC 3 EasyFix Operating Instructions

14 English
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
몇 WARNING
Risk of electric shock and burns
Trying to eliminate faults while the appliance is connect-
ed to the mains or has not yet cooled down is always
dangerous.
Remove the mains plug.
Allow the appliance to cool down.
The water shortage indicator light flashes red
The dry-run protection for the pump is deactivated.
1. Switch the device off and back on again.
2. Make sure that the decalcification cartridge has
been inserted correctly and there is sufficient water
in the reservoir.
The water shortage indicator light lights up con-
stantly in red
No water in the water reservoir.
1. Top up the water reservoir, see chapter Topping up
the water.
The steam lever cannot be pressed
The steam lever is locked with the child lock.
 Set the child lock (selector switch for steam volume)
to the front.
The steam lever is released.
No / little steam although there is water in the reser-
voir
The decalcification cartridge has not been inserted or
has been inserted incorrectly.
 Insert the decalcification cartridge or insert it cor-
rectly.
The decalcification cartridge has been removed while
topping up the water.
 Leave the decalcification cartridge in the device
when topping up.
New decalcification cartridge has been inserted.
 Press and hold the steam lever constantly.
The full steam output is reached after approximately
30 seconds.
Red indicator light "replace descaling cartridge"
lights up / flashes
Run time of the decalcification cartridge ends soon.
 Insert the new decalcification cartridge and reset the
maintenance indicator, see chapter Replacing the
decalcification cartridge.
The RESET key was not pressed after replacement of
the decalcification cartridge.
 Press and hold the RESET key for 4 seconds after
inserting the decalcification cartridge, see chapter
Replacing the decalcification cartridge.
Device switches off automatically
Run time for the decalcification cartridge has expired
 Insert the new decalcification cartridge and reset the
maintenance indicator, see chapter Replacing the
decalcification cartridge.
The RESET key was not pressed after replacement of
the decalcification cartridge.
 Press and hold the RESET key for 4 seconds after
inserting the decalcification cartridge, see chapter
Replacing the decalcification cartridge.
Technical data
Subject to technical modifications.
Customer Service
Australia
KÄRCHER Pty. Ltd
40 Koornang Road
Scoresby, Victoria 3179
1800 675 714 (Free Call)
www.karcher.com.au
New Zealand
Karcher Ltd.
66 Allens Road,
(09) 274-4603
www.karcher.co.nz
Electrical connection
Voltage V 220-240
Phase ~ 1
Frequency Hz 50-60
Protection class IPX4
Protection category I
Performance data
Heating capacity W 1900
Maximum operating pressure MPa 0.35
Heating-up time Seconds 30
Continuous steaming g/min 40
Maximum steam blast g/min 100
Filling quantity
Water reservoir l 1.0
Dimensions and weights
Weight (without accessories) kg 3.2
Length mm 360
Width mm 236
Height mm 252

Kärcher SC 3 EasyFix Specifications

General

AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Type	Cylinder steam cleaner
Capacity	1 L
Hose length	2 m
Product color	Black, Yellow
International Protection (IP) code	IPX4
Ready time	0.5 min
Steam pressure	3.5 bar
Adjustable steam	Yes
Cleaning surfaces	Glass, Hard floor, Tiles
Continuous steam performance	40 g/min

Weight and Dimensions

Depth	360 mm
Width	236 mm
Height	253 mm
Weight	3100 g