23
3.2.2 Using WPS
WPS (Wi-Fi Protected Setup) lets you connect a wireless device to the Extender’s network
without entering the wireless network passphrase or key. Instead, you use a WPS button or enter
a PIN to connect. WPS supports WPA and WPA2 wireless security. If your Extender network is
open (no wireless security is set), then connecting with WPS automatically sets WPA2 + WPA
wireless security on the Extender network.
To use the Extender WPS button to connect:
1. Locate the WPS button on the side of the Extender.
2. Press the Extender’s WPS button for 2 minutes, the Extender attempts to add a wireless
client (a wireless device) to its wireless network.
3. Within 2 minutes, press the WPS button on your wireless device, or follow the WPS
instructions that came with your wireless device. Your wireless device is now connected to
the Extender.
To Next Page
Loading...