Page 51
Copyright © 2012 Kato Engineering, Inc. All rights reserved
List of equipment required for installation and maintenance:
Test equipment Notices
Ammeter Clamp-on, 0 to 500 amp range for measuring of electrical cur rent.
Multimeter Digital, for measuring voltage, current, frequency and resistance.
Thermometer For measuring temperature in Celsius
Megger To measure insulation resistance.
Resistive Bridge To measure resistance of windings.
Special tools
Bearing puller For changing bearing.
Exciter puller For pulling exciter armature
Standard tools
Cable tool Crimping
Flashlight As required
Grease gun For lubricating bearings
Hammer Soft-faced
Lamp (incandescent) Safety light
Screwdrivers Standard, sized as required
Screwdrivers Phillips, sized as required
Wrench Adjustable, 12-inch
Wrench Torque 0 to 100 ft-lb
Wrench set Allen, 1/8 to 1/2 inch
Wrench set Socket, 1/4 to 1 Inch with 3/8 and 1/2 inch drive
Wrench set Standard, open-end/box-end combination sized 1/4 to 1 inch
Vacuum Electric with nonmetallic nozzle
Materials
Air Compressed, dry.
Corrosion inhibitor Nox-Rust VC #10 Oil or equivalent
Covering material Waterproof desiccant bags for protection from
moisture during long-term equipment storage
Detergent As required for cleaning
Gloves Chemical-protective
Gloves Electrical-protective
Heaters Space Heater, for eliminating excess moisture in damp areas and dry
out of motor or generator windings
Plastic Protection for long-term storage
Rags As required for cleaning
Water Warm and clean, for cleaning
Tags Warning and cautions
To Next Page
Loading...