W H E E L B L A N C E R
- 13 -
Decomposition is used on the outer side of the static balance or ALU-S
balancing mode and can be used to covertly attach the balancing block to the rim
behind the spokes. Press < START > to complete the ALU-S balance calculation
of the tire. When the imbalance value is displayed:
4.4.3.1 Number of input wheel frames
Enter any size, press < D > + < OPT > key
Press < ↑ > or < ↓ > to set the number of wheels (3-12).
Press < D > + < OPT > to confirm.
4.4.3.2 Unbalance of decomposition
Make any bar at 12 o 'clock and press < ALU > to decompose.
The center display displays "SPL".
Rotate the tire slowly until an imbalance value appears on the right display. At
this time, if there is a laser device, the corresponding weight of lead block is
attached behind the spokes in the laser indicated position, otherwise, the
To Next Page
Loading...
