To Next PageTo Next Page
Need help?Do you have a question about the KB Electronics Penta Power KBRG-255 and is the answer not in the manual?
General| Input Voltage | 115/230 VAC |
|---|---|
| Speed Range | 50:1 |
| Enclosure | NEMA 1 |
| Speed Regulation | 1% of base speed |
| Current Limit | Adjustable |
| Output Voltage | 0-90 VDC @ 115 VAC, 0-180 VDC @ 230 VAC |
| Control Type | SCR |
| Output Current | 25 Amps DC |
| Horsepower | 3 HP |
Details on connecting AC Line and Motor for the drive.
Setting the drive mode using jumper J7.
Information about factory-set trimpot configurations.
Recommendations for external fusing for the drive.
How to connect external signals like potentiometers.
Electrical specifications including voltage, current, and horsepower.
Performance parameters like voltage, frequency, speed range, etc.
Details on operating the drive in speed control mode.
Details on operating the drive in torque control mode.
Setting the tach-generator voltage input for jumper J4.
Selecting between armature and tach-generator feedback.
How to configure the current limit modes (TCL/NTCL).
Wiring configurations for the main speed potentiometer.
Adjusting acceleration and deceleration times.
Setting the bias for forward or reverse speed.
Setting potentiometer rotation for control output initiation.
Setting maximum DC current limits for torque control.
Stabilizing motor speed under varying loads.
Setting the maximum motor speed.
Adjusting the dynamic response of the control.
Setting the delay time for the Timed Current Limit feature.
