kbice FDFM1JA01 - Page 8

8
8
i n f o @ k b g o o d i c e.c o m
2. Flushing the unit for the first time use
 Plug the unit into power. You will hear 5 beeps if the reservoir is full.
 Press and hold the Clean button for 3 seconds to start the cleaning cycle
for flushing process, the Clean LED starts flashing slowly (it takes 30
minutes to complete and the Clean LED goes off).
 Unplug the unit when the flushing process is complete.
 Unhook the plugs/holders with drain tubes out of the unit back and lower
them to a bucket or sink.
 Press and hold the release buttons on the connectors to disconnect the
plugs/holders and release water.
 Reconnect and hook them back to the unit.
3. Making ice for the first time use
 Add clean potable water to MAX WATER FILL following instructions above.
 Plug the unit into power. You will hear 5 beeps if the reservoir is full.