24412 Main St. Suite 105, Carson, CA 90745
x Drain water following instructions in Section 1.
x Fill the water reservoir with clean potable water to MAX WATER FILL.
x Plug the unit into power. Add Water LED will flash quickly with 5 beeps if
the water reservoir is full.
x Press and hold the Clean button for 3 seconds to start cleaning for rinse
process. The Cleaning LED will illuminate. Press and hold the Clean
button again for 3 seconds in 5 minutes to stop rinsing.
x Drain water following instructions in Section 1.
x Repeat the rinse process 2~3 times.
12-How to clean the air vent every 3 months to prevent condenser
from blocking
x Unplug the unit.
x Use a condenser brush or a vacuum cleaner with an extended
attachment to clean the air vent.
x Plug the unit into power.
13-Cleaning the pump protector when it is dirty
x Drain water following instructions
in Section 1.
x Remove the water reservoir door
and lift up the pump protector.
x Clean the pump protector with
dishwashing liquid and rinse it
with potable water.
x Replace the pump protector and
press it down.
To Next Page
Loading...
