EasyManua.ls Logo

kbice FDFM1JA02 - Dispenser Care; Draining Water; Emptying Ice Bin and Reservoir; Troubleshooting: Add Water LED On

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
0
10
info@kbgoodice.com
DISPENSER CARE
CAUTION
Use food grade citric acid powder and chlorine bleach only.
Follow the product instructions carefully for First Aid.
Keep the unit out of reach of children.
Unplug the unit before you drain water.
1-How to drain water
x Unplug the unit.
x Unhook the plug/holder with drain tubes out of the unit back and lower
them to a bucket or sink.
x Press and hold the release buttons on the connectors to disconnect the
plug/holder and release water.
x Reconnect and hook them back to the unit.
2-How to empty the ice bin and water reservoir
x Dispense ice until no more ice comes out of the ice dispense point.
x Drain water following instructions in Section 1.
3-If the Add Water LED illuminates and the unit stops making ice
x Fill the water reservoir with clean potable water.
4-If the Add Wae LED den goes off when water is filled to MAX
WATER FILL
x Touch the water float as shown and move it upward to resettle. If it
works, you can skip the following steps.
x Unplug the unit.
x Fill the water reservoir with 12 teaspoons of food grade citric acid
powder.
x Wait for a few hours and plug the unit into power again.

Other manuals for kbice FDFM1JA02