19
3.5 Adjusting 'Control parameters'
The page is used for setting Flymentor 3D to fit the signal of transmitter. There are two
categories in the page, stick reverse and stick travel, see diagram 3.5.1. In fact, these
setting can also be set in transmitter, you can choose one way you like.
Diagram 3.5.1 Control page
*Attention: to avoid injury, please unmount main rotor and shut off power!
3.5.1 Stick reverse
Set stick reverse as following steps:
1）Ensure Flymentor 3D is mounted well, and all electronic devices have been connected
successfully.
KDS Flymentor 3D User Manual
07-17-平衡仪说明书(英文).pdf 22 2009-8-3 15:06:47
To Next Page
Loading...