Need help?Do you have a question about the KDS Flymentor 3D and is the answer not in the manual?
Steps to install the KDS USB driver and configure the control software.
Procedure for reading, adjusting, and saving parameters using the Flymentor 3D software.
Guidance on the physical placement and mounting of the Flymentor 3D unit on the helicopter.
Detailed steps for correctly setting the reverse direction of each servo.
Procedure to set neutral positions for servos for accurate swashplate alignment.
General| Brand | KDS |
|---|---|
| Model | Flymentor 3D |
| Category | Autopilot System |
| Language | English |
To Next Page