KC-S10 Mounting and installation instructions
V
15
© KEBA 2022
● Take into account the local electrical installation regulations, fire preven-
tion measures and accident prevention regulations as well as emer-
gency routes at this site.
● The device must not be installed in zones at potential risk of explosion
(EX environment).
● The device may only be installed in stationary applications.
● Do not install the device at locations where it is exposed to ammonia or
ammonia gas (e.g. in or at stables).
● Do not install the device at locations where falling objects could damage
the device (e.g. hung-up ladders or automobile tires).
● The device must not be exposed to direct spray water (e.g. neighboring
manual car wash facility, high-pressure cleaner, garden hose).
● The device should be protected against direct rain as far as possible to
prevent icing, hail damage or similar.
● If possible, the device should be mounted protected from direct sunlight.
● Observe the permissible environmental conditions (see "Technical
data").
Observe the internationally valid standards and comply with the nationally
applicable regulations.
6.2 Space requirements
The device must be installed with the following clearances to the surround-
ings.
Fig.6-7: Space requirement, specified in mm
To Next Page
Loading...