Keba KeContact KC-S10 - Purpose of the document; Required knowledge and abilities; Intended use of the device

KC-S10Introduction
V
6
© KEBA 2022
1.2 Purpose of the document
This document describes the complete installation of KC-S10.
1.3 Requirements
This document contains information for persons with the following require-
ments:
Target group Required knowledge and abilities
Electrician
Person who, due to his or her special training, expertise and experi-
ence as well as knowledge of current standards, is able to assess
the work performed and the possible hazards.
Knowledge of:
● current valid safety information,
● the mode of operation of the charging station,
● the displays and operating elements of the charging station,
● basics of network technology,
● diagnostic options,
● systematic fault analysis and rectification,
● the setting options on the charging station.
1.4 Intended use
The device is intended for monitoring and controlling the input voltage of a
charging station for electrically powered vehicles and may only be operated
in combination with a KEBA charging station.
Information
The device may only be operated with a charging station with software ver-
sion ≥ 1.15. Otherwise, proper operation is not ensured!
The device is suitable for indoor and outdoor use. The device must be in-
stalled on a wall in the vertical position. The subsurface for installation must
be flat and have the corresponding carrying capacity (e.g. brick wall, con-
crete wall). The respective national regulations must be observed with re-
gard to installation and connection.
The intended use of the device always includes the compliance with the en-
vironmental conditions for which this device was developed.
The device was developed, manufactured, inspected and documented in
compliance with the relevant safety standards. If the instructions and safety
instructions described for the intended use are observed, the product will
normally not pose a risk to the health of persons or damage to property.
Not observing the safety notes can result in risk of death, injuries and
damage to the device!
The device manufacturer assumes no liability for resulting claims!