Safety notes KeTop T50VGA
14 User's Manual, Version: 1.3
© KEBA 2007
NOTICE
• Turn off the power supply before opening the cable entrance area of
the KeTop. Otherwise the components could be destroyed or unde-
fined signals could occur.
• Make sure that nobody can fall over the cable to avoid that the device
falls to ground.
• Take care not to squeeze and thus damage the cable with any object.
• Do not lay the cable over sharp edges to avoid damaging the cable
sheath.
• If you do not use the device, hang it into the wall bracket KeTop WBxxx
provided for storage.
• Do not lay down the device with the operating side facing down to
avoid damaging the operating elements.
• Never lay the device onto unstable surfaces. It could fall to ground and
thus be damaged.
• Never lay the device close to heat sources or into direct sunlight.
• Avoid exposing the device to mechanical vibrations, excessive dust,
humidity or to strong magnetic fields.
• Never clean the device, operating panel and operating elements with
solvents, scouring agent or scrubbing sponges. For cleaning the de-
vice, use a soft cloth and a bit of water or a mild cleaning agent.
• Make sure that no foreign objects or liquids can penetrate into the de-
vice. Check at regular intervals the protective covers of the device, if
all housing screws are firmly tightened and if the housing or the cable
entry is damaged.
• If the device shows any defect, please send it, including a detailed er-
ror description, to your supplier or the relevant after-sales service of-
fice.
• If the KeTop is equipped with a touch screen, then operate the touch
screen with fingers or use a touch-pen. Never use sharp objects (e.g.
screwdriver,...) for operating the touch screen. This could damage the
touch screen.
To Next Page
Loading...