MAINTENANCE MANUAL
Speedster page 41
Adjust brewing lever
When too much lateral force is exerted on it, the brewing lever may bend and thus not
function properly. After straightening the lever, it is possible that you have to adjust the
position of the lever mechanism for correct functioning of the switches.
Materials needed
Spanner 13 mm, 10 mm
Allen key 5 mm, 2.5 mm
Procedure to align lever
1. Switch machine “off”.
2. Remove both side panels and upper body panel.
3. Make sure that the lever is straight; the part protruding from the front of the
machine should be parallel to the back end of the lever. The lever is most likely to
bend where it passes through the front panel.
4. With the lever in the middle position (pre-infusion, pump off) the wheel on the
upper switch should protrude halfway over the lever thickness at the point where
it touches the lever (see figure 28).
Figure 28. With the brewing lever in the middle position, the wheel of the upper switch
should protrude halfway over the thickness of the lever material.
5. When adjustments are necessary, loosen the two Allen bolts underneath the
frame (see figure 29).
6. Position the bottom bracket of the lever mechanism parallel to the side of the
frame with the wheel of the upper switch halfway over the lever thickness.
7. Tighten the two Allen bolts underneath the frame, re-check the position of the
lever mechanism (wheel position and parallel alignment with frame).
8. Switch machine “on”.
9. Check lever for proper operation.
10. Remount upper body panel first, then side panels.
To Next Page
