EasyManuals Logo

KEF HTB Series HTB2SE User Manual

KEF HTB Series HTB2SE
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
(F)
Connexions
(D)
Anschlüsse
(I)
Collegamenti
(ES)
Conexiones
(P)
Ligações
(NL)
Aansluitingen
(DK)
Forbindelser
(RU) Подключение
(PL) Połączenia
(CN) 连接
CONNECTIONS - WIRED MODE
Line Level - connected to amplifier subwoofer Output
(Set subwoofer frequency on the receiver/processor to
120Hz and “speakers to small” when using model HTS3001
speakers).
Уровень сигнала в линии – связан с расположенным на
усилителе выходом для сабвуфера (при использовании
динамиков HTS3001 установите на приемнике/процессоре
частоту сабвуфера равную 120 Гц и выберите в качестве
источника звука небольшие динамики).
Line Level – podłączone do wyjścia głośnika niskotonowego
(ustaw częstotliwość głośnika niskotonowego na odbiorniku na120
Hz i głośniki na „small” (małe) korzystając z głośników modelu
HTS3001).
Niveau ligne - connecté a la sortie “subwoofer
output”(regler la frequence sur 120Hz et les haut parleurs
sur “small”(petit) lorsque vous utilisez des haut-parleurs KEF
HTS3001)
Niederpegel-Anschluss - Wird an den Subwoofer-Ausgang
des Verstärkers angeschlossen (Stellen Sie die Subwoofer-
Frequenz Ihres Receivers/Prozessors auf 120 Hz ein, und
wählen Sie die Lautsprecher-Einstellung “klein”, wenn Sie
HTS3001-Lautprecher verwenden).
Line Level - collegato all’uscita sub-woofer dell’amplificatore
o del processore(che, nel caso di utilizzo di diffusori acustici
HTS3001, deve essere impostato su: frequenza di taglio per
il sub-woofer 120 Hz, “speakers small”).
Nivel de línea - Conectado a la salida de subwoofer del
amplificador (Ajuste la frecuencia del subwoofer en en
receptor/procesador a 120 Hz y los altavoces como “small-
pequeños” cuando use los altavoces HTS3001)
Nível de Linha - Conectado à saída do subwoofer do
amplificador (Ajuste a frequência do subwoofer no amplif.
sintonizador/processador para 120Hz e “speakers para small”
quando usa o modelo de colunas HTS3001).
Lijn Niveau - aangesloten op de subwoofer uitgang op de
processor/versterker (Kies in het menu van de processor/
versterker voor 120 Hz als overgangsfrequentie voor de
subwoofer en selecteer ‘kleine luidsprekers’ wanneer u
HTS3001 satellieten toepast).
Line Level - tilsluttet til “Subwoofer Output” på forstaerker/
receiver (saet delefrekvens/subwoofer-frekvens til 120Hz og
hojttalere til “små” når HTS3001 hojttalerene anvendes).
信号输入(LINE INPUT) — 连接至放大器的超低音输出(SUBWOOFER-OUT)
(当与 HTS3001 卫星音箱同时使用时,将影音放大器/处理器的超低音频率设
为120Hz,以及“speakers”设为“small”)。

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KEF HTB Series HTB2SE and is the answer not in the manual?

KEF HTB Series HTB2SE Specifications

General IconGeneral
BrandKEF
ModelHTB Series HTB2SE
CategorySubwoofer
LanguageEnglish

Related product manuals