HP MODEL 9825A
Use the following program to send a command string to
the Model 199 from a Hewlett-Packard Model 9825A and
display the instrument reading string an the computer
printer. The computer must be equipped with the
HPg8034A HPIB interface and a 9872A extended I/O ROM.
DIRECTIONS
1. From the front~panel. set the primary address of the Model
199 to 26.
2.Wth the power off, connect the Model 199 to the
98034A HPlB interface installed in the 9825A.
3.Enter the lines in the .p~mgram below, using the STORE
key after each line Line numbers are automaticaliy assign-
ed by the 9825A.
4.Press the 9825A RUN key and type in the desired com-
mand string at the command prompt. For example, to
place the instrument in ACV and autorange, type in FlROX
and press the CONT key.
5.The instrument reading string will then appear on the
computer ~p~rint out. A typjcal display is:
NAC”+O.OOOOOOE+O.
42
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...