DISPLAY MESSAGES
Message
/ Description
I
OVERFL
NO RANGE
NO FUNC
SHIFT
AC ONLY
TRIGGER
OVERRUN
INTERVAL
OVERRUN
UNCAL
NO DATA
Overrange
NO SCANNER
CAL LOCKED
Pressing range button while in dB
Invalid shifted function entry.
Shift mode in effect.
Selecting dB with unit not in AC.
Unit triggered before reading is
done.
Interval too short for present con-
figuration.
EEPROM failure uoon Dower UD.-
No data in data store when
recalling.
Pressing SCANNER or SCAN SETUP
with no scanner.
Attempting calibration with calibra-
tion locked.
CHAN 4 MAX
Channel 4 limit (Cpole)
CHAN 8 MAX Channel 8 limit IZ-pole1
CONFLICT Invalid state when calibrating.
NO REMOTE* Unit not in remote when program-
IDDC”
IDDCO’
ming over bus.
Illegal device-dependent command.
Illegal device-dependent command
cotion.
BIG STRING’ Siring longer than 10 characters
with D command.
TRANSERR’ Translator error.
‘IEEE-488 bus programming only.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General