The rear edge of the dock leveler should be level or
slightly (1/16" maximum) below dock level.
The top surface of the dock leveler should be level and a
smooth transition with the dock oor curb steel. The front
end should be level and parallel with the rear frame angle
for proper operation. Unequal adjustment of the front
supports may be required to obtain a level front edge.
Turn off all electrical power to the leveler if it has been
previously connected. Welding with dock levelers power
connected can damage the electrical components. A
ground must be attached to the leveler frame.
1/2"
To Next Page
Loading...
