4
The rating plate on your cement mixer may show
symbols. These represent important information
about the product or instructions on its use.
Wear hearing protection, eye protection
and breathing protection
Earthed Appliance
Conforms to relevant standards for
electromagnetic compatibility
DESCRIPTION OF SYMBOLS
SPECIFICATIONS
GENERAL SAFETY RULES
Nominal voltage: 230 – 240Vac, 50Hz
Power Output: 370W
Capacity:
Gross Bowl Volume
Unmixed Dry Volume
Mixed Wet Volume
130 litres (4.6cf)
100 litres (3.5cf)
85 litres (3cf)
Bowl Mouth Diameter 370mm
Bowl Speed 23 RPM
Motor Speed 1440 RPM
Net Weight: 64 KG
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, re and/or
serious injury.
Save all warnings and instructions for future
reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) cement mixer.
1. Work area safety
a. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
b. Do not operate power tools in explosive
atmospheres, such as the presence of ammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c. Keep children and bystanders away while
operating a power tool. Distractions may cause
you to lose control.
d. This power tool is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the power tool.
2. Electrical Safety
a. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adaptor plugs with earthed (grounded) power
tools. Unmodied plugs and matching outlets
will reduce the risk of electric shock.
b. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c. Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
d. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords
increase the risk of electric shock.
e. When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
f. To reduce the risk of electric shock, the
manufacturer recommends the use of a residual
current device with a rated residual current of
30mA or less at all times.
✔
CT0016_Kelso-FrontTipMixer-Manual_FA.indd 4 26/06/2015 12:13 pm
To Next Page
Loading...