Keltech KRAD M Series - Filter Kit Replacement with Encryption

Page 15
SET
FLR
321
Alarm Code
1. In case of filter alarm, a warning digit-code appears on
the controller screen.
2. Inform the authorized distributor or ser
vice.
3
. R
eplace the filter kit with an original spare part.
4
. Go to website mentioned below on phone or PC. Fill in the
required informa
tion. (Dryer Model No, Fil
ter Kit Serial No,
W
arning Digit Code). Note the 3-digit code on the website.
This is the solution code.
5. Enter the solution code to the controller via C
OD parameter.*
6. Process is completed, the alarm is to disappear
.
www.myintegratedfilter.com
SET
3 °C
*DIGIPRO
Unlock keybord by pressing on the “SET” button for 4 sec, find COD
parameter with “” button. Enter COD menu with “SET” button. Enter
the solution code with navigator keys. Press “SET” button to finish.
4.1.6 REPLACING FILTER KIT WITH ENCRYPTION CODE
FOR DIGIPRO CONTROLLER