EasyManuals Logo

Kelvinator KWH26CRC User Manual

Kelvinator KWH26CRC
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
In this mode, the fan will continue to run for 1 minute after compressor shuts off.
ENERGY SAVER:(only available in "COOLING" and "DRY" mode)
Press “ENERGY SAVER” to activate or disactivate the "ENERGY SAVER" Function.
Press +and - buttons simultaneously to lock or unlock the keypad. If the remote controller
is locked, the icon will be displayed on it, in that case, press any button, the mark will
flicker for three times. Repress the combination to unlock.
About switch between Fahrenheit and Centigrade
Under status of unit off, press "MODE" and " - " buttons simultaneously to switch
and .
INTRODUCTION FOR SPECIAL FUNCTION
ABOUT LOCK
Press this button at unit On, the light on the main unit will be turned on or off. Light On is
defaulted when power on.
LIGHT:
Press this button, the clock can be set up, icon blinks. Within 5 seconds, the value
can be adjusted by pressing " + " or " - " button, if continuously press this button for 2
seconds above, in every 1/2 seconds, one minute will be increased or decreased, if you
are still pressing the button after ten minutes increased or decreased, ten minutes will be
increased or decreased every 1/2 seconds. Druing blinking, repress the Clock button,
icon will be constantly displayed and it denotes the setting succeeded.
CLOCK

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kelvinator KWH26CRC and is the answer not in the manual?

Kelvinator KWH26CRC Specifications

General IconGeneral
BrandKelvinator
ModelKWH26CRC
CategoryAir Conditioner
LanguageEnglish

Related product manuals