Need help?Do you have a question about the Kemppi MF 33 and is the answer not in the manual?
General| Weight | 25 kg |
|---|---|
| Welding process | MIG/MAG |
| Protection Class | IP23 |
| Duty Cycle | 60% |
| Wire sizes | 0.8…1.2 mm |
Provides an overview of the FastMig MF equipment, its benefits, and the purpose of the operating manual.
Details the control panel and various connectors on the FastMig MF wire feeder.
Illustrates how to connect the FastMig MF system components, including power sources and welding guns.
Describes the 4-roll wire feed mechanism, including wire guide tubes, feed rolls, and gear wheels.
Explains how to assemble the MIG/MAG system, including mounting the wire feeder and connecting cables.
Guides on how to properly mount the MIG welding gun, ensuring correct wire guide tube and contact tip.
Details the procedure for mounting and securely locking the wire spool onto the feeder.
Explains the process of automatically feeding wire to the gun and troubleshooting common issues.
Describes how to adjust the pressure of the feed rolls for even wire feeding and proper braking.
Details how to adjust the spool brake to prevent wire from becoming too loose.
Explains the function of burn back time and how it can be adjusted.
Provides instructions on correctly connecting the ground cable for safe and efficient welding.
Covers the importance of shield gas, handling gas bottles, and setting the correct flow rate.
Step-by-step guide on how to install a gas bottle and connect the regulator.
Explains the operation of the main switch and pilot lamp for the power source.
Details the operation of the FastCool 10 cooling unit and troubleshooting.
Describes how the FastMig MF 33 can be hung from its handle.
To Next Page
