Name: Kemppi PROMIG EVOLUTION 501
Brand: Kemppi
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Control card A001

Error codes

Error 14:

• Wire feeder supply voltage >70 VDC

Error codes removal

•Error code Error 1 is removed, when Promig Evolution feeder is set to MIG

mode.

•Error code Error 2…4 is automatically removed in 5s, if the trigger is not

pulled. The cause of this error code should be eliminated before next start.

•Error codes Error 5…14 are removed during next start, if the causes of these

error codes are eliminated.

Questions and Answers:

Need help?

Do you have a question about the Kemppi PROMIG EVOLUTION 501 and is the answer not in the manual?

Kemppi PROMIG EVOLUTION 501 Specifications

General