Kemppi PROMIG EVOLUTION 501 - Page 8

Control card A001
Jumper functions (jumper block X7)
765
X7
8 9101 2 3 4
765 8 9103 4
4T HOT START not in use (MC / ML -panel).
X7
1 2
765 8 9103 4
• Crater filling in 4T procedure with synergic
MIG/PULSMIG (ML –panel).
• Crater filling in 4T (MC –panel).
• 4T procedure (without panel).
X7
1 2
765
8
9103 4
X7
1 2
• No crater filling (MC / ML -panel).
• 2T procedure (without panel).
7
65 8 9103 4
X7
1 2
7
6
5 8 9103 4
X7
1 2
Local control function is switched on
automatically, when remote controller is
disconnected.
Remote control function stays on, when remote
controller is disconnected.
4T HOT START in use (MC / ML -panel).