To Next PageTo Next Page
Need help?Do you have a question about the kENDALL SCD EXPRESS and is the answer not in the manual?
General| Product Type | Sequential Compression Device |
|---|---|
| Portability | Portable |
| Application | Deep Vein Thrombosis (DVT) Prophylaxis |
| Power Source | AC Power, Battery |
| Display | LCD |
| Pressure Range | 45 mmHg |
| Alarms | Sleeve Disconnect, Low Battery |
Use of the SCD EXPRESS System with Leg Sleeves for DVT and PE prophylaxis.
Use of the SCD EXPRESS System with Foot Cuffs for circulation enhancement and pain relief.
Contraindications for leg sleeves due to local conditions or vascular issues.
Contraindications for foot cuffs, especially for heart conditions.
Identifies components and indicators on the SCD EXPRESS Controller's front panel.
Instructions for placing the controller, connecting tubing, and power.
Steps to power on the controller and the initial LED sequence and tests.
How the controller detects and configures attached garments (leg or foot).
Verification of indicators, pressure adjustment, and normal operation.
Explanation of the patented method for optimizing compression timing.
Lists compatible Kendall garment reorder codes and tubing sets.
Options for configuring the controller for portability.
Details on battery charge levels via indicator LEDs.
Information on how the battery charges and expected run/charge times.
Explanation of the watchdog circuit's function in system resets.
Details troubleshooting for System High, High Pressure, and Low Pressure faults.
Details troubleshooting for System Pressure, Valve, Software, Pump, and Vent errors.
Details troubleshooting for Battery, Battery Error, and Temperature faults.
Purpose of the service manual and user serviceable parts.
Details on warranty coverage and procedures for returning units for service.
Instructions for cleaning and maintaining the fan screen.
Guidance on fuse replacement and electrical safety precautions.
Table outlining recommended maintenance tasks and frequency.
Procedures for cleaning the controller cabinet.
Overview of the controller's electrical/electronics and pneumatic operation.
Steps to enter the test access mode for service technicians.
Description of the Burn-In test used for manufacturing and battery calibration.
A chart listing available test modes and their functions.
Details on performing a general function test of the controller.
Procedure for calibrating the pressure transducer.
How to verify the accuracy of the pressure transducer calibration.
Instructions for running the self-test routine on the controller.
Procedure to identify leaks in the pneumatic system.
Steps to verify the performance of the pump, valves, and pressure delivery.
Information on the manufacturing test mode.
Steps for removing and installing the battery pack.
Instructions for removing and installing the compressor assembly.
Procedure for removing and installing the valve manifold and bed hook.
Steps for removing and installing the muffler component.
Instructions for removing and installing the power supply board.
Steps for removing and installing the fan and screen assembly.
Procedure for removing and installing the main controller board.
Exploded view diagram showing controller components and their labels.
A list of numbered parts corresponding to the exploded view diagram.
Continues the exploded view diagram showing controller components.
Diagram illustrating the pneumatic and electrical connections of the system.
Visual aids showing internal components and assembly points.
Visual aids showing internal components and assembly points.
