EasyManua.ls Logo

Kende FC-12B - Starting Operation Steps

Kende FC-12B
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
e. Press “CURRENT SELECT” button, you can choose the charge current you need.
Such as FAST or SLOW.
f. Confirm all choice is correct. After 5 seconds, till the digital on LED display and
“Charging” indicator are long bright, it means the charger is under charging working
condition.
g. -If user choose “6V” to charge a 6V battery ,after operate step a-f,the unit enter into a
normal charging condition.
-If user choose “6V” to charge a 12V battery, after operate step a-f,LED display will show
“FUL”.
-If user choose “12V” to charge a good 12V battery which voltage is more than 10.5V, after
operate step a-f, the unit enter into a normal charging condition.
-If user choose “12V” to charge a battery which voltage is less than 10.5V, the battery
charger will automatically reconditioning the battery. User can see reconditioning indicator
flashing, after 15 minutes, the unit will detect whether the battery is good or bad. If the
battery is good, it will be charged normally. If the battery is bad, the digital display will flash
“bAt”, then stop working.
h. When the charger is working normally, you can press “DISPLAY SELECT”, to check
charging voltage, battery capacity percent.
i. When the charger is charged, the LED display will be show “FUL”.
2. Starting operation
a. Charge the battery for 10-15 minutes according to steps a-f in the charging operation
section above.
i. Press the button of ENGINE STARTfor 3 seconds, the indicator below ENGINE
START” will be lighted, then you can start your vehicle and starting current will be showed
on LED Display.
ii. At most for 5 seconds, the charger will stop the starting mode and turn into rest mode.
Meanwhile, for the next time to go to start mode will be count down and showed on LED
Display like:180 179 178 - …..3 2 - 1.
b. If you need to exit ENGINE STARTmode, press ENGINE STARTonce, the light
below ENGINE START” will turn off, which represents that the charger has already exited
“ENGINE START and turn into charging mode.
Warning!
i. Do not crank engine for > 5s
ii. Wait approximately 180s between starting attempts
iii. Do not attempt to start more than three times. If three attempts fail, the vehicle’s
battery should be recharged 15-30 minutes
Warning!
The charging process must be monitored and the charging time limited. Please follow the
instructions of the battery manufacture.
Continuous connection of the charger can damage the battery.

Related product manuals