EasyManua.ls Logo

Kende FC-12B - End Charging Process

Kende FC-12B
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Pay attention to connect the Positive and negative of battery correctly .
End charging process:
1. Unplug from the AC outlet.
2. Disconnect the charging clamp(black) from the vehicle’s bodu, in exceptions from the
negative battery terminal(marked N or -)
3. Disconnect the positive chargiing clamp(red) from the positive battery
terminal(marked P or +).
WARNING!
4. Before use, carefully read the instruction manual and retain for future reference.
5. Start charging voltage is 3V, when users battery voltage is less 3V , the charger will
not have any function of the output.
6. For engine start, the maximum engine cranking time is 5sec with a minimum off time
of 180sec. Do not attempt Engine Start more than 3 times at one time.
7. The battery charger & engine starter is not weather proof. So care and common sense
must be exercised if using outdoors. Do not expose to moisture.
8. Never smoke near the charging area, it will cause a spark or charge near an open
flame.Please move the conductive materials away, which will short circuit the charger
or battery terminals.
9. This appliance is not intended for use by young children or infirm persons without
supervision and should be always be used responsibly and stored in an appropriate
place to prevent misuse.

Related product manuals