9
Attach hot water hose to hot water inlet valve. Screw coupling
by hand until it is snug. Use pliers to tighten couplings an
additional two-thirds turn. Repeat with cold water inlet valve.
Both hoses must be connected for washer to work properly.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
NOTE: To reduce risk of hose failure, replace the hoses every
5 years. Record hose installation or replacement dates for
future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Turn on water faucets to check for leaks from faucet and at
washer connection. A small amount of water may enter washer.
You will drain this in a later step.
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
Laundry Tub Standpipe Wall
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie (A). This will help reduce
the chance of drain water splashing on the oor.
A
A
A
6� Secure drain hose
4� Connect inlet hoses to washer
5� Check for leaks
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until clear.
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and the cold
water hose is connected to the cold water faucet.
3� Clear water lines
To Next Page
Loading...
Need help?
General