Why won't my Kenmore Vacuum Cleaner start?
If your Kenmore Vacuum Cleaner won't start, here's what you can check: * Ensure it's plugged into the wall outlet and the switch is in the FLOOR or CARPET position. * Check your household service panel for a tripped circuit breaker or blown fuse; reset the breaker or replace the fuse if necessary. * Make sure the hose electrical connections are secure; reconnect the hose ends if they are loose.
What to do if my Kenmore Vacuum Cleaner starts then shuts off?
If your Kenmore Vacuum Cleaner starts but shuts off, and the PowerMate® won't run when attached, it could be due to several reasons: 1. Check the hose electrical connection and reconnect the hose ends if necessary. 2. The overload protector in the PowerMate® may have tripped. Remove any items that may be caught or jammed, then reset it. 3. The thermal protector in the canister may have tripped. Reset the thermal protector.
How to improve the dirt pick-up of my Kenmore 125.22614610?
If your Kenmore Vacuum Cleaner isn't picking up dirt effectively, consider the following: * Empty and clean the dust cup if it's full or clogged. * Clean any clogged flow passages. * Adjust the pile height setting. * Adjust the suction control if it's open. * Replace the hose if there's a hole in it. * Change the agitator if the PowerMate® agitator is worn. * See BELT CHANGING AND AGITATOR CLEANING for worn or broken belt or dirty agitator or end caps. * See EMPTYING DUST CUP for incorrect dust cup installation. * See PRE-FILTER CLEANING for dust cup lid and dust cup missassembly.
Lists part numbers for belt, headlight bulb, filters, and primary filter.
Instructions for inserting the telescoping wand into the PowerMate®.
Instructions for inserting the handle into the telescoping wand and storing the hose.
Step-by-step guide on how to plug in and start the vacuum cleaner.
Instructions for attaching accessories to the vacuum cleaner's handle.
Instructions for attaching accessories to the telescoping wand.
Explains the function of the thermal protector and how to reset it.
Describes the motor protector's role in preventing overheating and damage.
Provides steps to check for and clear clogs in the vacuum cleaner's airflow passages.
Step-by-step instructions for removing the dust cup from the vacuum cleaner.
Guide on how to properly empty the dust cup and its contents.
Instructions for correctly reinserting the dust cup back into the vacuum cleaner.
Detailed steps for changing the belt and cleaning the agitator assembly.
Procedure for replacing the entire agitator assembly with a new one.
General| Brand | Kenmore |
|---|---|
| Model | 125.22614610 |
| Power Source | Corded Electric |
| Voltage | 120V |
| Amps | 12A |
| Filter Type | HEPA |
| Type | Canister |
| Weight | 22 lbs |
| Included Tools | Crevice tool, dusting brush, upholstery brush |
| Warranty | 1 year |
To Next Page