.... IIIIIIIIIIIIII I IIIIIIIIIHIIIIIIIIIIIIIIIIIIIIIII I II I
PICKING UP BOBBIN THREAD
1. Raise presser foot lever. Hold needle
thread loosely in left hand and rotate
handwheel toward you one complete
turn.
.
Bring bobbin thread up by pulling upper
thread.
®
3. Pull both threads under and to the back
of the presser foot, leaving 3 to 4 inches
of thread clear.
®
If you can not pick up bottom thread by
following above steps, then check:
1. Is thread through needle ?
2. Is thread tangled around needle ?
3. Is there 3 to 4 inches of thread coming out
of bobbin case ?
4. Is thread from bobbin case tangled ?
11
To Next Page
Loading...
