_4
.. . , , ,
•Fig. 5
4. Pull guide plate all the way forward
so that guide pin is at S. This will
enable you to start at one end of
the buttonhole. Drop guide plate
into place over gear on cover plate.
o
Pick up bobbin thread through
guide plate by turning hand wheel
and drawing thread to back of
machine. Place fabric between
presser foot and guide plate. Line
up edge of fabric with marked
indentation on guide. See Fig, 4.
If you wish all buttonholes to be
3/4 inch from edge of garment,
line up fabric with 3/4 inch mark-
ing each time you start sewing a
buttonhole.
34
To Next Page
Loading...
