LP Tank
□ Unscrew igniter caps from ignition modules. Insert 1 AA battery into each module with positive (+)
facing outword. Screw igniter caps back onto module.
□ Feed the regulator and hose through the hole in the right side panel.
□ LP tank is sold separately. Use only with an OPD (Overfill Protection Device) equipped LP tank. Fill
and leak check before attaching to grill and regulator.
□ Place LP tank into hole in bottom shelf with tank collar opening facing to the front as shown. Raise
tank holder to hold LP tank securely in place.
+
To Next Page
Loading...
