EasyManua.ls Logo

Kenmore 153.582500 - User Manual

Kenmore 153.582500
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
Use & Care Guide
Model No.
153.582400 40 Gallon Tall
153.582500 50 Gallon Tall
P/N 100263002 (0215)
Sears Brands Management Corporation,
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
LOW LEAD
CONTENT
Kenmore®
Electric
Water Heater
For potable water heating only.
Not suitable for space heating.
INSTALLER: Affi x these instructions to or near
the water heater.
OWNER: Retain these instructions for future
reference.
Si no puede leer o entender el inglés y necesita el manual de
instrucciones en español, puede solicitarlo al 1-800-821-2017. NO
TRATE DE INSTALAR U OPERAR ESTE CALENTADOR DE AGUA
SI NO ENTIENDE LAS INSTRUCCIONES. No hacer caso de esta
advertencia podría originar lesiones graves o mortales.
ADVERTENCIA

Table of Contents

Questions and Answers

  • M
    Melissa WalkerAug 8, 2025
    Why is there not enough or no hot water in my Kenmore Water Heater?
    • K
      kyle07Aug 8, 2025
      Several factors can cause a lack of hot water. First, ensure the cold water supply valve is completely open and that the electrical supply to your water heater is turned 'ON'. Check for any loose or blown fuses in the water heater circuit, and make sure the disconnect switch, if present, is in the 'ON' position. Verify that the electric service to your house hasn't been interrupted. Also, confirm that the thermostat is set to the desired temperature. During very cold weather, the incoming water will be colder, and the hot water usage may exceed the water heater's capacity. If you recently experienced very hot water followed by no hot water, the high-temperature shut-off system may be the cause.
  • C
    Charles SpearsAug 14, 2025
    What to do if my Kenmore 153.582500 Water Heater's water is too hot?
    • C
      Chelsea WyattAug 14, 2025
      If the water from your Kenmore Water Heater is too hot, adjust the thermostat to a lower setting.
  • D
    Donald GarnerAug 20, 2025
    What to do if my Kenmore 153.582500 T&P valve is dripping?
    • F
      fwhiteAug 20, 2025
      A dripping T&P valve on your Kenmore Water Heater can be due to several reasons. It may be caused by excessive water pressure, which can be resolved by using a pressure-reducing valve and a pressure relief valve. Another cause could be a closed system. Also, the T&P valve itself might be defective and need replacement.
  • L
    Leonard MoodyAug 27, 2025
    Why does my Kenmore 153.582500 Water Heater have a rumbling noise?
    • B
      bryan04Aug 27, 2025
      A rumbling noise in your Kenmore Water Heater is likely due to scale or mineral deposits. To resolve this, clean and replace the elements by following the 'Element Cleaning/Replacement' instructions.
  • M
    Melvin StewartSep 1, 2025
    How to get rid of hydrogen gas in hot water faucets of Kenmore 153.582500?
    • A
      Andrea HendersonSep 1, 2025
      To prevent any potential harm from hydrogen gas in your hot water faucets, it is recommended to open the hot water faucet and let it run for several minutes.

Summary

SAFE INSTALLATION, USE AND SERVICE

Safety Alert Symbol Definitions

GENERAL SAFETY

Safety Warnings and Precautions

Covers hazards like explosion, fire, electric shock, and burns from water heater operation.

INSTALLATION INSTRUCTIONS

Location, Drainage, and Wiring

Wiring Diagram and Connections

Water Piping Installation

Details hot water safety and steps for water piping connections.

Temperature-Pressure Relief Valve

Installation, Operation, and Safety

Details requirements for the T&P valve, including safety warnings and testing.

Filling the Water Heater

Filling Procedure and Safety

Instructions for filling the tank before operation and related safety precautions.

Wiring Diagram and Circuit Sizing

Electrical Circuit Sizing Guide

OPERATING YOUR WATER HEATER

Water Heater Start-Up Procedure

Step-by-step guide for initial power-up and system diagnostics.

Safety Shut-Off and Temperature Regulation

Describes the automatic shutdown for overheating and how to adjust temperature safely.

Modes and Adjustments

Temperature and Mode Settings

The Electronic Thermostat

Diagnostic LED Light and Error Codes

SERVICE AND ADJUSTMENT

Anode Rod Inspection and Replacement

Temperature-Pressure Relief Valve Operation

Instructions for manually testing the T&P valve annually to ensure proper function.

Draining and Flushing the Tank

Heating Element Replacement

Steps for safely replacing the heating elements of the water heater.

TROUBLESHOOTING

Start Up Conditions and Thermal Expansion

Hot Water Supply Problems

Diagnostic Code Chart: Energy Saver Module (ESM)

ESM Error Codes and Corrective Actions

Lists error codes displayed by the ESM and provides troubleshooting steps.

Diagnostic Code Chart: Electronic Thermostat (ET)

ET Error Codes and Corrective Actions

Lists error codes displayed by the ET and provides troubleshooting steps.

Troubleshooting Summary Chart

Common Problems and Solutions

LEAKAGE CHECKPOINTS

Identifying and Resolving Leaks

Kenmore 153.582500 Specifications

General IconGeneral
BrandKenmore
Model Number153.582500
TypeElectric Water Heater
Tank Capacity50 Gallons
Voltage240 V
Wattage4500 W
Warranty6 years
Fuel TypeElectric

Related product manuals