7e Select LOAD SIZE
Extra Extra
Small Large
LOAD SiZE
9. Select options (on some models)
2nd One Rinse
Rinse with Fabric Softener
One
Rinse
RINSE
2nd Rinse
with FabricSoftener
Select the load size setting most suitable for your load. Extra
Small will add a low amount of water for smaller loads and
Extra Large will add the most amount of water for large or
bulky loads, items need to move freely.
Oe Select WASH TEMP
Cool Warm
Cold
WASH TEMP
Hot
After selecting the load size, select the Wash Temp by turning
knob to desired temperature. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Warm water may be added to Colors that bleed
assist in soil removal and to help or fade
dissolve detergents. Light soils
Cold
This is the temperature water temp Dark colors that
from your cold water faucet. If bleed or fade
water is too cold, warm water may Light soils
be added to assist in soil removal
and help dissolve detergent.
10
Select the desired cycle options. If you are using fabric softener,
be sure to select one of the Rinse with Fabric Softener options.
f'_- O. Press START/PAUSE/Unlock Lid
to begin wash cycle
CANCEL
Hold 3 Sec,
O START
PAUSE
Unlock Lid
Press the START/PAUSE/Unlock Lid button to start the wash
cycle. When the cycle has finished, the Cycle Complete
status light will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of metal
hooks, zippers, and snaps.
Unlocking the ild to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/Unlock Lid; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
PAUSE/Unlock Lid again to restart the cycle.
If JJdJs left open for more than 10 minutes, the water wJJJ pump
out automatically.
To Next Page
Loading...
Need help?
General