Kenmore 2120 Series Use & Care Guide

48 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Use & Care Guide

Manual de uso y cuidado

Guide d'Ufilisation et d'Entretien

Encjlish / Espa_ol / Fran_ais

Table of Contents / indice / Table des Mati_res ...... 2

Models/Modelos/Mod61es: 2002 _, 2110 _, 2111_, 2118 _, 2120 _, 2129 _

Ke

®

opo

do

@

_:_ ¢©l©r numllls÷r_ nOmero de coWor_le num6ro de la couWeur

P/N W10280511B

Sears Brands Management Corporation

Hoffman Estates, IL 60179 U.S.A.

www.kenmore.com

www0sears.com

Sears Canada inc.

Toronto, Ontario, Canada MSB 2B8

www0sears.ca

Other manuals for Kenmore 2120 Series

Use And Care Guide52 pages

Questions and Answers:

S
Stacy DeanAug 18, 2025
Why is my Kenmore 2120 Washer not draining or spinning and loads are still wet?
- F
  Frank HinesAug 18, 2025
  Your Kenmore washer may not be draining or spinning properly, leaving loads wet, for several reasons. Small items might be caught in the pump or between the basket and tub, slowing drainage; adding a 2nd Rinse to the selected cycle can help. Using cycles with lower spin speeds removes less water than high-speed cycles, so select the recommended cycle/speed spin for your garment. Reduce load size to improve water removal, as tightly packed loads prevent proper spinning. Ensure the drain hose is correctly installed, not taped over, and not clogged. Always measure and follow detergent directions; too much detergent can cause extra suds. To remove these extra suds, select Rinse/Spin without adding detergent.
G
granttannerAug 23, 2025
Why Kenmore 2120 Washer stops mid cycle?
- A
  Angela KelleyAug 23, 2025
  The lid of your Kenmore Washer must be closed for it to operate. The washer also pauses during certain phases of the cycle, so avoid interrupting it. If the washer is tightly packed, this can prevent it from running correctly. Remove several items, rearrange the load evenly in the basket, close the lid, and press START/PAUSE/Unlock Lid. Avoid adding more than 1 or 2 additional items after the cycle has started. Adding extra water to the washer is not recommended.
B
Brian OconnellAug 26, 2025
What to do if my Kenmore Washer won't run or fill?
- C
  Crystal AndersonAug 26, 2025
  If your Kenmore Washer won’t run or fill, or stops working, start by checking the power supply. Ensure the power cord is plugged into a grounded 3-prong outlet and that the outlet has power. Avoid using an extension cord. Also, reset any tripped circuit breakers or replace blown fuses. Note that the lid must be closed for the washer to run, and the washer will pause during certain cycles. If the washer is tightly packed, remove several items and rearrange the load evenly. Do not add more than 1 or 2 additional items after a cycle has started, and do not add more water to the washer.
O
obrienshawnAug 27, 2025
How to fix wet loads after spin cycle in Kenmore Washer?
- A
  allison23Aug 27, 2025
  If loads are still wet after a wash in your Kenmore Washer, make sure to empty pockets and use garment bags for small items to prevent them from getting caught in the pump. Cycles with lower spin speeds remove less water, so use the recommended cycle and spin speed for your garments. To remove extra water, select the Drain/Spin cycle. Also, ensure the drain hose is correctly installed and not clogged. Too much detergent can also slow down draining and spinning, so always measure and follow detergent directions. To remove extra suds, select Rinse/Spin without adding detergent.
S
santiagoerikaAug 30, 2025
What to do if my Kenmore Washer won’t run or fill, or stops working?
- C
  ccampbellAug 30, 2025
  If your Kenmore washer isn't running, filling, or stops mid-cycle, check the following: Ensure the power cord is plugged into a grounded 3-prong outlet and avoid using extension cords. Verify there's power to the outlet, and reset any tripped circuit breakers or replace blown fuses. Note that if problems persist, contact an electrician. Make sure the lid is closed for the washer to operate. The washer may pause during certain cycle phases or to reduce suds; avoid interrupting the cycle. If the washer spins the load before filling to determine load size, remove several items and rearrange the load evenly. Do not add more than 1 or 2 additional items after a cycle has started, and do not add more water to the washer.
M
Mrs. Mikayla BurtonSep 1, 2025
Why is my Kenmore Washer load not rinsed properly?
- S
  Shannon ReyesSep 1, 2025
  If your Kenmore washer load isn't rinsing properly, make sure the hot and cold inlet hoses are not reversed. Both hoses must be attached and have water flowing to the inlet valve, and both hot and cold water faucets must be on. Check that the inlet valve screens on the washer are not clogged and remove any kinks in the inlet hose. Too much detergent can cause excessive suds, preventing the washer from operating correctly, so always measure detergent and follow directions based on load size and soil level. Load garments in loose heaps evenly around the basket wall, use a cycle designed for the fabrics being washed, and add only 1 or 2 garments after the washer has started.
H
hollysmithSep 4, 2025
Why are there incorrect or wrong wash or rinse temperatures in my Kenmore 2120?
- E
  Erin CopelandSep 4, 2025
  If you're experiencing incorrect wash or rinse temperatures with your Kenmore washer, first ensure that the hot and cold inlet hoses are not reversed. Both hoses must be attached to both the washer and faucet, with both hot and cold water flowing to the inlet valve. Check that the inlet valve screens are not clogged, and remove any kinks in the hoses. Also, be aware that Energy Star washers use cooler wash temperatures than older models, including cooler hot and warm washes, and all rinses are cold.

Kenmore 2120 Series Specifications

General

Brand	Kenmore
Model	2120 Series
Category	Washer
Language	English

Related product manuals

Preview: Kenmore 2125 Series

Kenmore 2125 Series

Kenmore 2110 Series

Kenmore 2135 Series

Kenmore 110.21302013

Kenmore 110.21302010

Kenmore Elite 110.2108200

Preview: Kenmore 2927000

Kenmore 2927000

Preview: Kenmore 111.2914

Kenmore 111.2914

Kenmore 796.29002