EasyManua.ls Logo

Kenmore 253.35010 - User Manual

Kenmore 253.35010
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P/N 2020213A0851
WINDOW TYPE ROOM AIR CONDITIONER
Kenmore®
CLIMATISEUR DE TYPE FENÊTRE
Sears Brands Management Corporation
Hoçman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
English / Français
Use&CareGuide
Manuel d’utilisation et d’entretien
Models/Modèles: 253.35005, 253.35008, 253.35010, 253.35012

Table of Contents

Questions and Answers

  • L
    Linda EvansAug 16, 2025
    What to do if Kenmore 253.35010 doesn't cool the room and there is ice behind front panel?
    • M
      Mary HernandezAug 16, 2025
      If your Kenmore Air Conditioner does not cool the room and there is ice behind the front panel, consider the following: * If the outside temperature is below 16 °C, set the mode to FAN ONLY and the fan speed to the fastest setting to defrost the coil. * If the filter is dirty, open the front panel, remove the filter, rinse or vacuum it, replace it, and close the panel. * If the BTU size is too large, a lower capacity unit may be required depending on the size of the room being cooled.
  • A
    alexis34Aug 20, 2025
    What to do if my Kenmore Air Conditioner will not operate?
    • S
      Sean LindseyAug 20, 2025
      If your Kenmore Air Conditioner won't operate, check these potential causes: * Ensure the power supply cord is firmly pushed into a live wall outlet with the correct voltage. * Replace any blown fuse with a time delay type or reset the circuit breaker. * Press the ON/OFF button to ensure the unit is turned ON. * Adjust the temperature to a lower setting if it's warmer than the room temperature. * Allow 3 minutes for the compressor to restart if the unit was recently turned OFF and ON. * Press the ON/OFF button if the timer shut the unit OFF. * If the touch pad and remote are unresponsive, unplug the unit for 10 seconds to reset the controls. * Press the RESET button on the plug head if the power cord has tripped.
  • J
    Joshua HamptonAug 23, 2025
    Why does my Kenmore Air Conditioner keep blowing fuses or tripping the circuit breaker?
    • R
      Ricky RubioAug 25, 2025
      If your Kenmore Air Conditioner blows fuses or trips the circuit breaker, try these solutions: * Replace the fuse with a time delay type or reset the circuit breaker. * Unplug or relocate some electrical devices that share the same circuit. * Ensure the unit is plugged into a single circuit outlet if it's rated over 7.5 amps. * Do not use an extension cord to run the unit. * Turn the unit OFF and wait 3 minutes before restarting if it was turned OFF and ON too quickly.
  • N
    Nancy HarringtonAug 27, 2025
    Why does my Kenmore 253.35010 Air Conditioner turn on and off by itself?
    • D
      daniellefrancisAug 27, 2025
      If your Kenmore Air Conditioner turns on and off by itself, it could be due to these reasons: * When the outside temperature is extremely hot, set the fan speed at the fastest setting for maximum cooling. * If the ENERGY SAVER feature is on, note that it doesn't circulate air continually; switch to COOL mode for constant air circulation. * If the timer turned the unit ON or OFF, use the ON/OFF button to control the unit.
  • J
    Justin PatrickAug 31, 2025
    Why is my Kenmore 253.35010 running too much?
    • C
      Cynthia BellAug 31, 2025
      If your Kenmore Air Conditioner runs too much, here's what might be happening: * When Energy Saver mode is active, the inside blower continues operating for one minute to use as much cooling as available in the evaporator. * If you've replaced an older unit, the newer, higher efficiency air conditioner may run longer to cool the room, but total energy consumption is less due to the higher efficiency. * If the BTU size is too small, you might need a higher capacity unit depending on the room size.
  • C
    Caroline IrwinSep 3, 2025
    Why is my Kenmore 253.35010 dripping water inside the room?
    • J
      John BurtonSep 3, 2025
      If water is dripping from your Kenmore Air Conditioner inside the room, it's likely due to improper installation. The unit should be mounted on a 1/4" downward slope to the outside (1/2 bubble on a carpenter’s level) to ensure proper drainage. Reposition or shim the cabinet as needed, but do not drill the drain pan.
  • C
    Casey SmithSep 7, 2025
    Why will the remote not operate my Kenmore 253.35010 Air Conditioner?
    • R
      ryancrossSep 7, 2025
      If the remote will not operate your Kenmore Air Conditioner, verify that the batteries are installed properly. Also, the remote may not work properly when used at extreme angles to the front of the unit.
  • C
    ccabreraNov 11, 2025
    What to do if Kenmore 253.35010 Air Conditioner doesn't cool the room but there is no ice behind front panel?
    • H
      hernandezjaclynNov 11, 2025
      If your Kenmore Air Conditioner isn't cooling the room and there's no ice behind the front panel, consider the following: * Clean or replace the filter by opening the front panel, removing the filter, rinsing or vacuuming it, replacing it, and closing the panel. * Set the temperature to a lower setting if it is warmer than the current room temperature. * Note that the unit isn't designed to cool if the room temperature is below 16 °C. * Ensure that furniture, drapes, blinds, or other obstructions are cleared from the front of the unit. * Ensure that leaves, dirt, branches, or other obstructions are cleared from the back of the unit. * Close any open doors, windows, registers, etc. * Allow sufficient time for cooling if the unit was recently turned on, especially in a larger ...

Summary

Master Protection Agreements

Read and Save These Instructions

Record Your Model and Serial Numbers

Record essential identification numbers for the appliance.

Important Safety Instructions

Operation of Current Device

Details on the power supply cord's current detection device and its testing.

Air Conditioner Features

Electronic Control Panel Overview

Identifies buttons and displays on the unit's control panel.

Remote Control Operation

Description of the remote control's features and battery replacement.

Air Conditioner Operations

Unit On;Off and Mode Selection

Instructions for turning the unit on/off and selecting modes like Cool.

Temperature and Fan Speed Adjustment

How to adjust temperature settings and fan speeds (Low, Med, High, Auto).

Advanced Air Conditioner Features

Energy Saver, Sleep, and Timer Modes

Explains the operation of Energy Saver, Sleep, and Timer functions.

Filter Reset Indicator

How to check and reset the filter indicator light.

Additional Information

Operational Notes and Fault Codes

Details on operational delays, temperature settings, fault codes, and auto-restart.

Fresh Air Vent Control

Explains the operation of the fresh air vent control for different airflow modes.

Care and Maintenance

Air Filter Cleaning

Instructions for cleaning or vacuuming the air filter.

Cabinet and Winter Storage

Guidelines for cleaning the cabinet and storing the unit for winter.

Energy Saving Ideas

Troubleshooting Guide

Unit Not Operating Issues

Diagnoses and solutions for when the air conditioner will not operate.

Cooling and Ice Issues

Troubleshooting steps for poor cooling or ice formation problems.

Troubleshooting Continued

Unit Runs Too Much & Water Dripping

Solutions for excessive operation time and water dripping inside or outside.

Remote and Sound Issues

Troubleshooting remote control problems and identifying normal sounds.

Service and Support

Kenmore 253.35010 Specifications

General IconGeneral
BrandKenmore
Model253.35010
CategoryAir Conditioner
LanguageEnglish

Related product manuals