EasyManua.ls Logo

Kenmore 253.35012 - User Manual

Kenmore 253.35012
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P/N 2020213A0851
WINDOW TYPE ROOM AIR CONDITIONER
Kenmore®
CLIMATISEUR DE TYPE FENÊTRE
Sears Brands Management Corporation
Hoçman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
English / Français
Use&CareGuide
Manuel d’utilisation et d’entretien
Models/Modèles: 253.35005, 253.35008, 253.35010, 253.35012

Table of Contents

Questions and Answers

  • S
    Scott RogersAug 16, 2025
    What to do if Kenmore 253.35012 doesn't cool the room and there is ice behind front panel?
    • J
      Jennifer SimmonsAug 16, 2025
      If your Kenmore Air Conditioner does not cool the room and there is ice behind the front panel, consider the following: * If the outside temperature is below 16 °C, set the mode to FAN ONLY and the fan speed to the fastest setting to defrost the coil. * If the filter is dirty, open the front panel, remove the filter, rinse or vacuum it, replace it, and close the panel. * If the BTU size is too large, a lower capacity unit may be required depending on the size of the room being cooled.
  • C
    Courtney ElliottAug 19, 2025
    What to do if my Kenmore 253.35012 will not operate?
    • A
      Austin SmithAug 19, 2025
      If your Kenmore Air Conditioner won't operate, check these potential causes: * Ensure the power supply cord is firmly pushed into a live wall outlet with the correct voltage. * Replace any blown fuse with a time delay type or reset the circuit breaker. * Press the ON/OFF button to ensure the unit is turned ON. * Adjust the temperature to a lower setting if it's warmer than the room temperature. * Allow 3 minutes for the compressor to restart if the unit was recently turned OFF and ON. * Press the ON/OFF button if the timer shut the unit OFF. * If the touch pad and remote are unresponsive, unplug the unit for 10 seconds to reset the controls. * Press the RESET button on the plug head if the power cord has tripped.
  • O
    odavisAug 25, 2025
    Why does my Kenmore 253.35012 keep blowing fuses or tripping the circuit breaker?
    • M
      mayoamyAug 25, 2025
      If your Kenmore Air Conditioner blows fuses or trips the circuit breaker, try these solutions: * Replace the fuse with a time delay type or reset the circuit breaker. * Unplug or relocate some electrical devices that share the same circuit. * Ensure the unit is plugged into a single circuit outlet if it's rated over 7.5 amps. * Do not use an extension cord to run the unit. * Turn the unit OFF and wait 3 minutes before restarting if it was turned OFF and ON too quickly.
  • M
    Mr. Robert Cameron MDAug 27, 2025
    Why does my Kenmore 253.35012 Air Conditioner turn on and off by itself?
    • P
      patrickriveraAug 28, 2025
      If your Kenmore Air Conditioner turns on and off by itself, it could be due to these reasons: * When the outside temperature is extremely hot, set the fan speed at the fastest setting for maximum cooling. * If the ENERGY SAVER feature is on, note that it doesn't circulate air continually; switch to COOL mode for constant air circulation. * If the timer turned the unit ON or OFF, use the ON/OFF button to control the unit.
  • K
    Kristen FullerAug 31, 2025
    Why is my Kenmore 253.35012 running too much?
    • A
      Ann RamirezAug 31, 2025
      If your Kenmore Air Conditioner runs too much, here's what might be happening: * When Energy Saver mode is active, the inside blower continues operating for one minute to use as much cooling as available in the evaporator. * If you've replaced an older unit, the newer, higher efficiency air conditioner may run longer to cool the room, but total energy consumption is less due to the higher efficiency. * If the BTU size is too small, you might need a higher capacity unit depending on the room size.
  • J
    Jaime JonesSep 4, 2025
    Why is my Kenmore 253.35012 dripping water inside the room?
    • R
      Rebecca TaylorSep 4, 2025
      If water is dripping from your Kenmore Air Conditioner inside the room, it's likely due to improper installation. The unit should be mounted on a 1/4" downward slope to the outside (1/2 bubble on a carpenter’s level) to ensure proper drainage. Reposition or shim the cabinet as needed, but do not drill the drain pan.
  • M
    Mark HarrisSep 8, 2025
    Why will the remote not operate my Kenmore 253.35012 Air Conditioner?
    • D
      Deborah RodriguezSep 8, 2025
      If the remote will not operate your Kenmore Air Conditioner, verify that the batteries are installed properly. Also, the remote may not work properly when used at extreme angles to the front of the unit.
  • M
    Mark LevyNov 11, 2025
    What to do if Kenmore 253.35012 doesn't cool the room but there is no ice behind front panel?
    • T
      Teresa SanchezNov 11, 2025
      If your Kenmore Air Conditioner isn't cooling the room and there's no ice behind the front panel, consider the following: * Clean or replace the filter by opening the front panel, removing the filter, rinsing or vacuuming it, replacing it, and closing the panel. * Set the temperature to a lower setting if it is warmer than the current room temperature. * Note that the unit isn't designed to cool if the room temperature is below 16 °C. * Ensure that furniture, drapes, blinds, or other obstructions are cleared from the front of the unit. * Ensure that leaves, dirt, branches, or other obstructions are cleared from the back of the unit. * Close any open doors, windows, registers, etc. * Allow sufficient time for cooling if the unit was recently turned on, especially in a larger ...

Summary

Master Protection Agreements

Sears Installation Service

Information on professional installation services for home appliances.

Read and Save These Instructions

Record Your Model and Serial Numbers

Instructions to log unit model and serial numbers for future reference.

Important Safety Instructions

WARNING For Your Safety

Safety advice regarding flammable materials and vapors.

WARNING Prevent Accidents

Precautions to prevent fire, electrical shock, or injury during use.

Electrical Information

Details on electrical requirements, grounding, and proper wiring for safety.

Grounding type wall receptacle

Explanation of the importance and function of grounding receptacles.

Operation of Current Device

Instructions for testing the power cord's current detection device.

Air Conditioner Features

ELECTRONIC CONTROL

Overview of the control panel and its functions.

REMOTE CONTROL

Details on the remote control operation and battery replacement.

TOUCH PAD

Explanation of the unit's touch panel controls.

Air Conditioner Features

Unit On;Off Operation

How to turn the unit on and off using the ON/OFF button.

Cool Mode Operation

Instructions for selecting and using the Cool mode.

Temperature Setting Adjustment

How to adjust the temperature using the UP and Down arrow buttons.

Fan Speed Adjustment

Guide on selecting fan speeds (Low, Med, High).

Auto Fan Feature

Explanation of the Auto Fan mode's automatic speed adjustment.

Fan Only Mode

How to use the Fan Only mode for air circulation.

Air Conditioner Features

Energy Saver Mode

How to use the Energy Saver mode for efficient operation.

Sleep Feature Operation

Instructions for activating the Sleep mode for temperature adjustments.

Timer Function Operation

Guide on setting the timer for automatic operation.

Filter Check and Reset

Information on the filter indicator and reset procedure.

Additional Things You Should Know

Fault Codes

Explanation of error codes like "ES" and "AS" and their meanings.

Auto Re-Start Feature

How the unit restarts after a power outage.

Fresh Air Vent Control

Operation of the fresh air vent control on specific models.

Air Directional Louvers

Louver Adjustment

How to adjust air direction using louvers and auger wheels.

Care and Cleaning

Air Filter Cleaning

Instructions for cleaning the air filter.

Cabinet Cleaning

How to clean the unit's cabinet and front panel.

Winter Storage

Guidance on storing the air conditioner during winter.

Energy Saving Ideas

Tips for Efficient Operation

Advice on maximizing energy efficiency and reducing consumption.

Troubleshooting Guide

Unit Will Not Operate

Solutions for when the unit fails to start or operate.

Unit Blows Fuses or Trips Circuit Breaker

Troubleshooting steps for electrical issues like blown fuses or tripped breakers.

Unit Turns On and Off By Itself

Reasons and fixes for the unit cycling unexpectedly.

Does Not Cool - Ice Behind Front Panel

Diagnosing and resolving cooling issues with ice formation.

Does Not Cool - No Ice Behind Front Panel

Troubleshooting cooling problems without ice formation.

Troubleshooting Guide

Unit Runs Too Much

Addressing issues where the unit runs excessively.

Water Dripping Inside Room

Solutions for water leaks inside the room.

Water Dripping Outside Room

Explaining water dripping outside the unit.

Remote Will Not Operate

Troubleshooting problems with the remote control.

Normal Sounds

Typical Operating Sounds

Identifying and understanding normal operational sounds of the unit.

Kenmore 253.35012 Specifications

General IconGeneral
Voltage115V
Weight40 lbs
Power Supply115V / 60Hz
Filter TypeWashable
TypeWindow
Amperage10.8A
Amps10.8A

Related product manuals